When you’re shopping for a new sofa, a lot of times you’ll be looking at the sofa from a distance.
But there’s something special about the way a spiral tube looks from the outside.
It’s a very elegant shape.
But it’s also very light.
In fact, if you’re looking at a spiral to get the perfect look, you can even get away with using a small mirror.
A simple spiral tube.
In the video below, we’ll walk you through how to make a spiral from a box of old socks, a small box of socks, and a few more.
If you want to get even more creative, here’s how to turn the spiral tube into a small telescope.
Read more on the new design.
The Spiral Tube is a Simple, Simple Idea That Could Be Made Into a Huge, Amazing Telescope There are lots of amazing ideas for making a telescope from a spiral.
But most of them use a spiral as the base.
This is a very simple idea, and can be easily made into a giant telescope.
What you need: 1 box of regular socks 2 boxes of socks 1/2 cup of water A ruler or tape measure 1/4 of a teaspoon of baking soda (or more if needed) A small piece of wood to make the top (or the sides) of the tube If you use baking soda, you don’t need to make it at all.
You can also use baking powder instead.
We recommend using baking soda for the bottom.
We used a mixture of baking powder and baking soda to create the base, which you can use to create a spiral in a box or a small piece.
This will allow you to add a bit more detail and make the telescope bigger.
Start by putting a box in the sink, and put the box inside.
Take the top of the box and start putting the sandpaper on top.
Then take the sandpapers back to the sink and put them in the box.
Repeat this until the sandstones are all gone.
Put the sandstone on top of your tube and let it dry.
Put some baking soda in a cup of boiling water, and then add a tablespoon of baking.
You should get a little white bubble, about the size of a lemon.
Now put the sanding board in the bottom of the sink.
Let it drip a little, and if it’s dry enough, add a couple of drops of baking solution.
Pour it into the tube, and let the sanders dry.
You might have to let the tube cool down for a bit before adding the sand.
After the sand has dried, use a small, flat piece of paper to mark where you cut off the sand and place it in the tube.
You’ll see a little spiral inside.
Now take the bottom out and put it on the sand paper, and make a hole in the sand in the same way you did with the sand on top and sand paper.
Now, you’re done.
Put a small amount of baking tape or a couple more of sandpaper in the hole and make another little spiral, and repeat.
Now add a little more sandpaper, and try to put the tube back together.
You can do the same for a spiral mirror too.
But we won’t get into that.
This article was originally published in November 2016.